Datalogic MAGELLAN 900i - Databar Expanded Reverse Retry

ENTER/EXIT PROGRAMMING MODE
168 MAGELLAN™ 900I
DataBar Expanded Reverse Retry
Enables/disables the reading of out of specification labels where the last row has been
printed in reverse.
• When enabled, DataBar Expanded Stacked labels that have the last row incorrectly
printed in reverse will be re-decoded.
• When disabled, DataBar Expanded Stacked labels that have the last row incorrectly
printed in reverse will not be read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
DataBar Expanded Reverse Retry = Disable
DataBar Expanded Reverse Retry = Enable
DEFAULT
04D800(CR)
04D801(CR)