CODE 39 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
171
Code 39 Check Character Calculation
Enables/disables calculation and verification of an optional Code 39 check character. When
disabled, any check character in label is treated as a data character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
If check calculation is disabled, the risk is increased that a mis-
read can occur.
Code 39 Check Character Calculation = Disable
Code 39 Check Character Calculation = Enable
DEFAULT
005500(CR)
005501(CR)
To Next Page
Loading...
