ENTER/EXIT PROGRAMMING MODE
172
MAGELLAN™ 900I
Code 39 Check Character Transmission
Enables/disables transmission of optional Code 39 check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
Code 39 Check Character Transmission = Disable
Code 39 Check Character Transmission = Enable
008A00(CR)
008A01(CR)
To Next Page
Loading...
