CODE 39 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
173
Code 39 Full ASCII
Enables/disables the ability of the scanner to translate to Code 39 full ASCII labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Code 39 Full ASCII = Disable
Code 39 Full ASCII = Enable
DEFAULT
022F00(CR)
022F01(CR)
To Next Page
Loading...
