CODE 39 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
177
Code 39 Length 2
If Code 39 Length Control is set to Fixed-Length decoding, this feature specifies Code 39
second fixed length. If Code 39 Length Control is set to Variable-Length decoding, this fea-
ture specifies the maximum label length.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode,
Set Code 39 Length 2 on page 177 below. You’ll need to cover any
unused barcodes on this and the facing page to ensure that the scanner reads only
the barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre-
sent the desired label length. The selectable range for this option is 00, no second
fixed length, or 01 to 50. Pad all single digit numbers with a leading zero to yield a
two-digit entry (00-50).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
When in Fixed Length mode, if Length 2 is set to the value of 00,
then only Length 1 will apply
Set Code 39 Length 2
Default setting for this feature = 32 (length = 50)
04B3(CR)
DEFAULT
To Next Page
Loading...
