CODE 32 ITALIAN PHARMACODE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
179
Code 32 Start Stop Character Transmission
Enables/ disables transmission of start and stop characters for Code 32.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
Code 32 Start Stop Character Transmission = Disable
Code 32 Start Stop Character Transmission = Enable
DEFAULT
00F600(CR)
00F601(CR)
To Next Page
Loading...
