ENTER/EXIT PROGRAMMING MODE
182
MAGELLAN™ 900I
Code 128 Transmit Function Characters
Enables/disables transmission of Code 128 function characters 1, 2, 3, and 4.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
Disabled is the recommended setting for all interfaces.
Code 128 Transmit Function Characters = Disable
Code 128 Transmit Function Characters = Enable
DEFAULT
02C700(CR)
02C701(CR)
To Next Page
Loading...
