Datalogic MAGELLAN 900i - Code 128 Minimum Read

ENTER/EXIT PROGRAMMING MODE
184 MAGELLAN™ 900I
Code 128 Minimum Read
This feature specifies the minimum number of consecutive Code 128 decodes before is
accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Code 128 Minimum Read = 1
Code 128 Minimum Read = 2
Code 128 Minimum Read = 3
Code 128 Minimum Read = 4
DEFAULT
006F01(CR)
006F02(CR)
006F03(CR)
006F04(CR)