ENTER/EXIT PROGRAMMING MODE
188
MAGELLAN™ 900I
Code 128 Stitching
Enables/disables stitching for Code 128 labels. When parts of a Code 128 barcode are pre-
sented to the scanner with this feature enabled, the barcode parts will be assembled by the
scanner’s software, and the data will be decoded if all barcode proofing requirements are
met.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Code 128 Stitching = Disable
Code 128 Stitching = Enable
06A800(CR)
06A801(CR)
To Next Page
Loading...
