ENTER/EXIT PROGRAMMING MODE
192
MAGELLAN™ 900I
I 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Interleaved 2 of 5 check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
This feature applies only when I 2 of 5 Check Character Calcula-
tion is enabled. This item is ignored when the advanced feature,
Full Label Edit, is enabled.
I 2 of 5 Check Character Transmission = Disable
I 2 of 5 Check Character Transmission = Enable
008B00(CR)
008B01(CR)
To Next Page
Loading...
