ENTER/EXIT PROGRAMMING MODE
194
MAGELLAN™ 900I
I 2 of 5 Length Control
This feature specifies whether variable-length or fixed-length decoding will be set for I 2 of
5.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
I 2 of 5 Length Control = Variable Length
I 2 of 5 Length Control = Fixed Length
DEFAULT
022B00(CR)
022B01(CR)
To Next Page
Loading...
