MANUFACTURER APPROVED CLEANING MATERIALS
PRODUCT REFERENCE GUIDE
9
CLEANING
Exterior surfaces and scan windows exposed to spills, smudges or debris accumulation
require periodic cleaning to assure best performance during scanning. Use a clean, lint-free
cloth or paper towel dampened with a nonabrasive, mild, water-based cleaner to wipe
away stains, smudges, fingerprints, spills, etc. from the scan window and exterior surfaces.
Manufacturer Approved Cleaning Materials
Datalogic recommends the use of the following cleaners on its products.
CAUTION
DO NOT use abrasive cleaning agents or abrasive pads to clean this product.
Harsh chemicals, disinfectants, and cleansers can cause damage which will
adversely affect scanning performance.
DO NOT spray
cleaners directly
on the scanner!
CAUTION!
APPROVED CLEANERS
•Hydrogen Peroxide (not to exceed a 3% solution)
•Chlorine bleach (not to exceed a 0.25% solution)
•Mild detergent and water
•lsopropyl Alcohol (not to exceed a 70% solution)
CAUTION
Use of the above cleaners in combination with each other is not recommended
and may constitute a health hazard. Follow all specified safety precautions
when using any cleaning solution.
To Next Page
Loading...
