ENTER/EXIT PROGRAMMING MODE
200
MAGELLAN™ 900I
Codabar Start Stop Character Match
Enables/disables the requirement that Codabar start and stop characters match.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Codabar Start Stop Character Match = Disable
Codabar Start Stop Character Match = Enable
DEFAULT
023200(CR)
023201(CR)
To Next Page
Loading...
