ENTER/EXIT PROGRAMMING MODE
202
MAGELLAN™ 900I
Codabar Check Character Transmission
Enables/disables transmission of an optional Codabar check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
Applies only when Codabar Check Character Calculation is
enabled. This item is ignored when the advanced feature, Full
Label Edit, is enabled.
Codabar Check Character Transmission = Disable
Codabar Check Character Transmission = Enable
008C00(CR)
008C01(CR)
To Next Page
Loading...
