MSI ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
215
MSI Number of Check Characters
Specifies number of MSI check characters to be calculated and verified.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode below representing the desired number of MSI check characters to
be calculated and verified. You’ll need to cover any unused barcodes on this and the
facing page to ensure that the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
Check characters are always modulus 10.
MSI Number of Check Characters = 1
MSI Number of Check Characters = 2
DEFAULT
021700(CR)
021701(CR)
To Next Page
Loading...
