Datalogic MAGELLAN 900i - Standard 2 of 5 Check Character Calculation

ENTER/EXIT PROGRAMMING MODE
222 MAGELLAN™ 900I
Standard 2 of 5 Check Character Calculation
Enables/disables calculation and verification of an optional Standard 2 of 5 check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
If check character calculation is disabled, the risk is increased
that a misread can occur. When disabled, any check character in
a barcode is treated as data character.
Standard 2 of 5 Check Character Calculation = Disable
Standard 2 of 5 Check Character Calculation = Enable
DEFAULT
049600(CR)
049601(CR)