ENTER/EXIT PROGRAMMING MODE
230
MAGELLAN™ 900I
IATA Check Character Transmission
Enables/disables transmission of an optional IATA check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
This feature applies only when IATA Check Character Calculation is enabled.
This item is ignored when the advanced feature, Full Label Edit, is enabled.
IATA check character transmission = disable
IATA check character transmission = enable
034D00(CR)
034D01(CR)
To Next Page
Loading...
