PLESSEY ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
235
Plessey Length 2
If Plessey Length Control is set to Fixed-Length decoding, this feature specifies Plessey sec-
ond fixed length. If Plessey Length Control is set to Variable-Length decoding, this feature
specifies the maximum label length.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode
Set Plessey Length 2 on page 235. You'll need to cover any unused
barcodes on this and the facing page to ensure that the scanner reads only the bar-
code you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre-
sent the desired label length. The selectable range for this option is 00, or 01 to 50;
even numbers only. Pad all single digit numbers with a leading zero to yield a two-digit
entry (01-50).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
When in Fixed Length mode, if Length 2 is set to the value of 00 (zero), then
only Length 1 will apply.
Set Plessey Length 2
Default setting for this feature = 32 (length = 50)
060B(CR)
DEFAULT
To Next Page
Loading...
