ENTER/EXIT PROGRAMMING MODE
236
MAGELLAN™ 900I
ANKER PLESSEY
Anker Plessey Enable
Enables/disables the ability of the scanner to decode Anker Plessey labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Anker Plessey = disable
Anker Plessey = enable
DEFAULT
052000(CR)
052001(CR)
To Next Page
Loading...
