ANKER PLESSEY ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
237
Anker Plessey Check Character Calculation
Enables/disables calculation and verification of an optional Anker Plessey check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
If check character calculation is disabled, the risk is increased that a misread
can occur. When disabled, any check character in a barcode is treated as data
character.
Anker Plessey Check Character Calculation = disable
Anker Plessey Check Character Calculation = enable
DEFAULT
056900(CR)
056901(CR)
To Next Page
Loading...
