ENTER/EXIT PROGRAMMING MODE
238
MAGELLAN™ 900I
CODE 39 CIP
Code 39 CIP Enable
Enables/disables the ability of the scanner to decode Code 39 CIP labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Code 39 CIP = disable
Code 39 CIP = enable
DEFAULT
053900(CR)
053901(CR)
To Next Page
Loading...
