CODE 39 CIP ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
239
Code 39 CIP Start Stop Character Transmission
Enables/disables transmission of Code 39 CIP start and stop characters.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
This item is ignored when the advanced feature, Full Label Edit, is enabled.
Code 39 CIP Start Stop Character Transmission =
Disable
Code 39 CIP Start Stop Character Transmission =
Enable
DEFAULT
059600(CR)
059601(CR)
To Next Page
Loading...
