CODE39 PZN ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
241
CODE39 PZN
Code39 Pzn Enable
Enables/disables the ability of the scanner to decode Code39 Pzn labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
Code39 Pzn = disable
Code39 Pzn = enable
DEFAULT
053D00(CR)
053D01(CR)
To Next Page
Loading...
