CODE39 PZN ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
243
Code39 Pzn Check Character Transmission
Enables/disables transmission of an optional Code39 Pzn check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
This item is ignored when the advanced feature, Full Label Edit, is enabled.
Code39 Pzn Check Character transmission = disable
Code39 Pzn Check Character transmission = enable
059E00(CR)
059E01(CR)
To Next Page
Loading...
