IF YOU MAKE A MISTAKE...
PRODUCT REFERENCE GUIDE
15
If You Make a Mistake...
If, during a programming session, you find that you are unsure of the scanner’s settings or
wish to reset the scanner’s configuration, use the Return to Factory Settings label below to
return the scanner’s configuration to the factory settings. Scanning this label will also reset
any changes made during previous programming sessions.
Return to Factory Settings
Scan the bar code below to return the scanner to the default settings configured at the fac-
tory for the currently active interface. This bar code is typically used to return the scanner
to a “known” operating state when the present programming status is not known, faulty, or
suspect.
CAUTION
Use this bar code with caution, since it will reset ALL features that may have been pro-
grammed since the scanner’s installation.
NOTE
DO NOT scan the Enter/Exit Programming Mode bar code before and after scanning this
bar code.
Standard Product Default Settings
To Next Page
Loading...
