MICRO PDF 417 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
261
Micro PDF 417 128 Emulation
This feature specifies which AIM ID to use for Micro PDF 417 labels when performing Code
128 or EAN 128 emulation.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode below for the desired setting. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Micro PDF 417 128 Emulation = Micro PDF AIM ID and
label type when emulating EAN128 or Code 128
Micro PDF 417 128 Emulation = Code 128 / EAN128 AIM
ID and label type when emulating EAN128 or Code 128
DEFAULT
032700(CR)
032701(CR)
To Next Page
Loading...
