QR CODE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
265
QR Code URL Link Enable
Enables/Disables the decoding of QR codes with a URL link on imagers.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
QR Code URL Link = Disable
QR Code URL Link = Enable
DEFAULT
03A100(CR)
03A101(CR)
To Next Page
Loading...
