ENTER/EXIT PROGRAMMING MODE
266
MAGELLAN™ 900I
GS1 QR CODE ENABLE
This feature controls the ability of the scanner to decode GS1 QR Code labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
GS1 QR Code = Disable
GS1 QR Code = Enable
DEFAULT
047500(CR)
047501(CR)
To Next Page
Loading...
