ENTER/EXIT PROGRAMMING MODE
280
MAGELLAN™ 900I
POSTAL CODE SELECTION
Enables/disables the ability of the scanner to decode labels of the specified postal symbol-
ogy.
POSTNET
Postnet Enable
Enables/disables the ability of the scanner to decode Postnet labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Postnet = Disable
Postnet = Enable
DEFAULT
052100(CR)
052101(CR)
To Next Page
Loading...
