POSTNET ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
281
Postnet Check Character Calculation
Enables/disables calculation and verification of an optional Postnet check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
If check character calculation is disabled, the risk is increased
that a misread can occur. When disabled, any check characters in
a barcode are treated as data characters.
Postnet Check Character Calculation = Disable
Postnet Check Character Calculation = Enable
DEFAULT
056A00(CR)
056A01(CR)
To Next Page
Loading...
