ENTER/EXIT PROGRAMMING MODE
282
MAGELLAN™ 900I
PLANET CODE
Planet Code Enable
Enables/disables the ability of the scanner to decode Planet Code labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Planet Code = Disable
Planet Code = Enable
DEFAULT
052200(CR)
052201(CR)
To Next Page
Loading...
