ENTER/EXIT PROGRAMMING MODE
284
MAGELLAN™ 900I
ROYAL MAIL
Royal Mail Enable
Enables/disables the ability of the scanner to decode Royal Mail labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Royal Mail = Disable
Royal Mail = Enable
DEFAULT
052300(CR)
052301(CR)
To Next Page
Loading...
