AUSTRALIA POST ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
287
AUSTRALIA POST
Australian Post Enable
Enables/disables the ability of the scanner to decode Australia Post labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Australia Post = Disable
Australia Post = Enable
DEFAULT
052500(CR)
052501(CR)
To Next Page
Loading...
