ENTER/EXIT PROGRAMMING MODE
290
MAGELLAN™ 900I
SWEDEN POST
Sweden Post Enable
Enables/disables the ability of the scanner to decode Sweden Post labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Sweden Post = Disable
Sweden Post = Enable
DEFAULT
052800(CR)
052801(CR)
To Next Page
Loading...
