ENTER/EXIT PROGRAMMING MODE
298
MAGELLAN™ 900I
Code39 Laposte Check Character Transmission
Enables/disables transmission of an optional Code39 Laposte check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
Code39 Laposte Check Character Transmission =
Disable
Code39 Laposte Check Character Transmission =
Enable
059B00(CR)
059B01(CR)
To Next Page
Loading...
