Datalogic MAGELLAN 900i - Label ID

PRODUCT REFERENCE GUIDE 301
5. Scan the END barcode once to finish the string, then scan END again to exit Program-
ming Mode.
6. The resulting message string would appear as follows:
Scanned barcode data:12345
Resulting message string output: $12345
LABEL ID
A Label ID is used to identify a barcode (symbology) type. It can be appended previous to or
following the transmitted barcode data depending upon how this option is enabled. This
feature provides options for configuring custom Label IDs individually per symbology. If you
wish to program the scanner to always include an industry standard label identifier for ALL
symbology types, see the feature,
AIM ID on page 85.
The Label ID is a customizable code of up to three ASCII characters (each of which are hex
00-7F) followed by a control character (00-01), This control character, when set to zero,
does nothing. When set to one, it appends the symbology’s AIM ID to the Label ID.
Figure 10. Label ID Position Options
See Label ID on page 86 for programming barcodes. See Appendix D, Factory Default Settings,
for a listing of common symbologies.
NOTE
If all 20 characters will be used in the prefix or suffix, do not scan the END
barcode to finish the string. It is done automatically.
NOTE
When the control character is set to 01 for UPC-A and UPC-E, it expands
the label to EAN-13 and thus follows the EAN-13 Label ID settings.
OR
Prex SuxLabel ID Label IDBar Code DataAim ID