LENGTH CONTROL
PRODUCT REFERENCE GUIDE
305
Length Control
Fixed Length Decoding:
When fixed length decoding is enabled, the scanner will decode a
barcode if the label length matches one of the configurable fixed lengths.
Variable Length Decoding:
When variable length decoding is enabled, the scanner will
decode a barcode if the label length falls in the range of the configurable minimum and
maximum length.
Configuring Fixed Length Decoding:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the Fixed Length Decoding barcode for the desired symbology.
3. Scan the Enter/Exit Programming Mode barcode at the top of the page.
4. Set Length 1 to the first fixed length by following the
Length 1, Length 2 Programming
Instructions
below.
5. Set Length 2 to the second fixed length (or to ‘00’ if there is only one fixed length) by
following the
Length 1, Length 2 Programming Instructions below.
Configuring Variable Length Decoding:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the Variable Length Decoding barcode for the desired symbology.
3. Scan the Enter/Exit Programming Mode barcode at the top of the page.
4. Set Length 1 to the first variable length by following the
Length 1, Length 2 Program-
ming Instructions
below.
5. Set Length 2 to the second variable length by following the
Length 1, Length 2 Pro-
gramming Instructions
below.
Length 1, Length 2 Programming Instructions
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the Set Length 1 or Set Length 2 barcode for the desired symbology.
3. Turn to
Appendix Appendix C and scan the two digits (zero padded) representing the
length in decimal notation. The number of characters that can be set varies, depend-
ing upon the symbology. Reference the page for your selected symbology to see spe-
cific variables.
4. Scan the Enter/Exit Programming Mode barcode at the top of the page.
To Next Page
Loading...
