Datalogic MAGELLAN 900i - LED and Beeper Indicators

LED AND BEEPER INDICATORS
320 MAGELLAN™ 900I
LED AND BEEPER INDICATORS
The scanner’s beeper sounds and its green LED illuminates to indicate various functions or
errors on the scanner. The tables below list these indications. The scanner’s functions are
programmable, and so may or may not be turned on. For example, certain indications such
as the power-up beep can be disabled using programming barcode labels.
LED
INDICATION
INDICATION COMMENT
Power-on
indication
Bright green flash
Indicates the scanner has fin-
ished all its power up tests and is
now ready for operation.
Good Read
Indication
Bright green flash
Indicates a barcode has been
read and decoded.
Scanner Ready Constant dim green
The scanner is ready for opera-
tion. The LED is also configu-
rable to off when idle and ready
for operation.
Sleep Mode
Green LED slowly and continu-
ously changes from off to dim to
off.
The scanner is in Sleep Mode. To
wake the scanner up, move an
object in front of its window or
press the button atop the unit.
This indication is configurable
and may be programmed to
behave differently.
Host Disable
Constant green flash at 1 Hz
(100mS on, 900mS off)
The scanner is disabled due to
receiving a disable command
from the POS terminal.
Diagnostics
Varies (see "Error Codes" on
page A-322 for more informa-
tion)
The LED can provide diagnostic
feedback if the scanner discov-
ers a problem during SelfTest.
Prog. Mode See Host Disable above.
The scanner is in Programming
Mode.