ERROR CODES
322
MAGELLAN™ 900I
ERROR CODES
If an error is detected, the scanner will sound a long low tone (for three seconds) and flash
its LED, indicating a failure. When this occurs, press the Scanner Pushbutton to hear the
error code. If it is configured to do so, the scanner will sound a series of beeps correspond-
ing to the error code and/or flash its LED simultaneous to the beeps. The table below
describes what these codes mean and what action should be taken for each.
NUMBER OF
LED FLASHES/
BEEPS
ERROR CORRECTIVE ACTION
1 Configuration
Contact Helpdesk for assis-
tance
2 Interface
6 Main PCB
10 Button Error
11 USB Device
12 Imager Module
13 Software ID Failure
14 Software Fatal Fault
To Next Page
Loading...
