PRODUCT REFERENCE GUIDE
327
APPENDIX D
FACTORY DEFAULT SETTINGS
The following table provides a listing of the most common factory settings for the interfaces
shown.
Factory Default Settings
NOTE
Some of the individual interfaces listed in the defaults table below appear in
the same column since they share similar feature settings with few (if any)
exceptions.
Keep in mind though, that the actual configuration storage area for each inter-
face is unique and that updates & changes to factory defaults can be made at
any time without notice.
FEATURE
DEFAULT
MASTER
RS-232
RS-232
WINCOR-
NIXDORF
KEYBOAR
D
USB-COM USB OEM
General Scanner Features
1D Double Read Timeout 28 (400ms) 28 (400ms) 28 (400ms) 28 (400ms) 28 (400ms) 28 (400ms)
2D Double Read Timeout 46 (700ms) 46 (700ms) 46 (700ms) 46 (700ms) 46 (700ms) 46 (700ms)
Double Read Table Size 7 entries 7 entries 7 entries 7 entries 7 entries 7 entries
1D Inverse Read Control
00
(disable)
00
(disable)
00
(disable)
00
(disable)
00
(disable)
00
(disable)
2D Inverse Read Control
00
(disable)
00
(disable)
00
(disable)
00
(disable)
00
(disable)
00
(disable)
Handheld State On Time
01 (2.0
seconds)
01 (2.0
seconds)
01 (2.0
seconds)
01 (2.0
seconds)
01 (2.0
seconds)
01 (2.0
seconds)
Center Zone Enable 0 (off) 0 (off) 0 (off) 0 (off) 0 (off) 0 (off)
Center Zone Size
OA (10 per-
cent)
OA (10 per-
cent)
OA (10 per-
cent)
OA (10 per-
cent)
OA (10 per-
cent)
OA (10 per-
cent)
Sleep Mode Timer 5 minutes 5 minutes 5 minutes 5 minutes 5 minutes 5 minutes
Power On Alert
01 (play
tone)
01 (play
tone)
01 (play
tone)
01 (play
tone)
01 (play
tone)
01 (play
tone)
External Read Indicator
(ERI)
00 (low) 00 (low) 00 (low) 00 (low) 00 (low) 00 (low)
To Next Page
Loading...
