PRODUCT REFERENCE GUIDE
347
APPENDIX F
HOST COMMANDS
ACCEPTING RS-232 AND USB COM COMMANDS
The scanner responds to the following RS-232, RS232-WN and USB COM commands:
If one of the above commands is received, the scanner will perform the steps indicated for
the command. Host commands for other interfaces are also available. Contact Tech Support
for more details.
Information about additional features can be found in
"Image Capture to the Host by Host
Command" on page 40
.
COMMAND ASCII HEX COMMENT
Enable Scanner E 0x45
Disable Scanner D 0x44
Reset Scanner R 0x52
Not On File Indication F 0x46 Long series of beeps
Beep Good Read Tone B 0x42
Beeps if Good Read Beep is
enabled
Force Good Read Tone n/a 0x01 Beeps regardless of beep setting
Identification request i 0x69
Returns long response
a
a. Call Tech Support for information.
Health request h 0x68
Returns long response
a
Status request s 0x73
Returns long response
a
Beep on ASCII BEL ! 0x07
Beeps if Beep on ASCII BEL is
enabled
To Next Page
Loading...
