ENTER/EXIT PROGRAMMING MODE
24
MAGELLAN™ 900I
Center Zone Size
Specifies the Center Zone size as a percentage of the full image.
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode
Set Center Zone Size below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre-
sent the desired percentage in hex. The selectable range is 01 - 100%. Pad all numbers
with leading zeros to yield a two-digit entry (01-100).
4. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Set Center Zone Size
Default setting for this feature is: 10 percent
1504\r
DEFAULT
To Next Page
Loading...
