ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
25
Sleep Mode Timer
This feature specifies the amount of time of inactivity (with no label reads) before the scan-
ner enters sleep mode.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode
Set Sleep Mode Timer below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C to represent
the desired time interval. The selectable range is 000-255 in 15 second increments.
Pad all numbers with leading zeros to yield a three-digit entry (000-255).
4. Scan the Enter/Exit Programming Mode barcode at the top of the page to exit Pro-
gramming Mode.
Set Sleep Mode Timer
Default setting for this feature is: 5 minutes
03AF(CR)
DEFAULT
To Next Page
Loading...
