ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
29
Good Read LED Idle State
This feature specifies the state of the green scanner LEDs when the scanner is idle and
ready to read a label. Options are:
• Off
• On dim
To set the Scanner LEDs Idle State:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Scanner LED Idle State = Off
Scanner LED Idle State = On Dim
030101(CR)
030102(CR)
To Next Page
Loading...
