ENTER/EXIT PROGRAMMING MODE
30
MAGELLAN™ 900I
Scanner Control Button Options
Configure the Scanner Control Button to one of the following modes of operation:
• Enable all functions: Volume, tone, diagnostics and reset.
• Enable only volume, tone and reset.
• Enable reset only.
• Disable all button functions
To set the desired Scanner Control Button Option:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Scanner Control Button = Enable All Functions
Scanner Control Button = Enable Only Volume Tone and
Reset
Scanner Control Button = Enable Reset Only
Scanner Control Button = Disable All Functions
05AF00(CR)
05AF01(CR)
05AF02(CR)
05AF03(CR)
To Next Page
Loading...
