ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
31
Good Read Beep Control
This feature enables/disables scanner beep upon successfully decoding of a label.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Good Read Beep Control = Disable
Good Read Beep Control = Enable
006700(CR)
006701(CR)
To Next Page
Loading...
