ENTER/EXIT PROGRAMMING MODE
32
MAGELLAN™ 900I
Good Read Beep Frequency
Adjusts the scanner’s good read beep to sound at low, medium, or high frequency (controls
the beeper’s pitch/tone).
• Low
• Medium
• High
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Good Read Beep Frequency = Low
Good Read Beep Frequency = Medium
Good Read Beep Frequency = High
001400(CR)
001401(CR)
001402(CR)
To Next Page
Loading...
