Datalogic MAGELLAN 900i - Good Read Beep Volume

ENTER/EXIT PROGRAMMING MODE
34 MAGELLAN™ 900I
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are five selectable volumes, with
each volume increment adding approximately five decibels to the previous level:
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
• Low • Medium High
• Medium Low • High
• Medium
Good Read Beep Volume = Low
Good Read Beep Volume = Medium Low
Good Read Beep Volume = Medium
Good Read Beep Volume = Medium High
Good Read Beep Volume = High
001900(CR)
001901(CR)
001902(CR)
001903(CR)
DEFAULT
001904(CR)