Datalogic MAGELLAN 900i - Good Read When to Indicate

ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 35
Good Read When to Indicate
This feature specifies when the scanner will provide indication (beep and/or flash its green
LEDs) upon successfully reading a barcode.
• Good Read = Indicate after decode.
• Good Read = Indicate after transmit.
• Good Read = Indicate after CTS goes inactive, then active.
This mode applies to RS-232 STD and RS-232 WN interfaces only. If set in other inter-
faces, “Indicate after decode” mode will be implemented.
• Good Read = Indicate after each output structure proofed.
When beeping after each output structure decoded, if there are multiple output
structures, there is a delay after the beep has finished. This delay is equal to the
Good
Read Beep Length on page 33.
To set the Good Read When to Indicate feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the desired mode barcode from those provided below You’ll need to cover any
unused barcodes on facing pages to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Good Read When to Indicate = After Decode
Good Read When to Indicate = After Transmit
Good Read When to Indicate = After CTS goes Inactive,
Then Active
Good Read When to Indicate = After Each Output
Structure Proofed
DEFAULT
009900(CR)
009901(CR)
009902(CR)
009903(CR)