ENTER/EXIT PROGRAMMING MODE
36
MAGELLAN™ 900I
Illumination During Disable Mode
This feature allows illumination to be turned off when the scanner is in “disable” mode. It
determines if the imager illumination is controlled by host interface enable/disable com-
mands.
Disable = Illumination is not controlled by host enable/disable commands, illumination
stays on when disabled.
Enable = Illumination is controlled by host enable/disable commands, illumination is on
when enabled and off when disabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Illumination During Disable Mode = Disable
Illumination During Disable Mode = Enable
063A00(CR)
063A01(CR)
To Next Page
Loading...
